Supplies Needed Template of choice - I am using Butterfly Flutterby Creations Here Tube of choice - I used Of which you need license you can purchse this Here Scrap peices of choice - I used Sara's Rock On PTU Of which you can purchse Here On your template Hold down Shift & D Close out the original. Delete the copyrite information layer. On the record sleeve layer, Selections - Select all - Float and defloat. With a paper of choice copy and paste as a new layer. Selections - Invert - Hit delete on your keyboard. Back onto the original sleeve layer and add a dropshadow of choice, I used 4 - 4 - 25 - 5 - Black. Repeat the above steps for the back record sleve. Select the layer Polaroid frame 1 again repeating the same steps we previously used above. For this and the poloroid frame 2 layer. Repeat the above steps for the Inners of the poloroids and the small inners of the film rolls, Remember to add dropshadows to each original layer you use. Select inside the original Poloroid layer Selections select all selections float defloat Copy and paste your tube of choice as a new layer, On your tube layer seections invert and hit delete. The next art is optional, Go to Adjust, Hue and Saturation, Colourize turn both to 0. Again this is optional Effects - Plugins - Xero - Porcelain Load with the following settings 50 - 128 - 128 - 0 - 0 - 255 Hit load. Repeat the above step on the other poloroid layer. On the large inner of the sleeve, Selections - Select all - Foat - defloat- Copy and paste another tube of choice as a new layer, Again Adjust - Hue and Saturation - Colourise - leave both set at zero. Repeat the plugin step as explained above. Assuming you purchased the same scrap i am using, Copy and paste any other embelishments that you wish to use. Adding a dropshadow to each layer you add. Add any names and copyrite information required, Save as you would normally. Thats it tutorial complete Thanks for trying my tuturial.