Supplies Needed Tube/Image of choice – I am using Sebastien Serrano You need a license t use this work please visit MyPspTubes Scrap kit of choice – This is a PTU scrapkit Called Charming by Sugar Kissed Scraps Purchased from Scraphappiness Open a blank canvas550 x 550 Flood fill with white. Open up a letter set of choice from your kit.I choose letter set 2. With your magic wand settings as follows Add (Shift) – RGB Value – Tolerance 50 – Feather 0 Select inside your letter This is quiet hard to doTry and get all the lighter area filledOnce happy with selection copy and paste a tube of choice as a new layerOnce happy with placement selections invert hit delete. Lower the opacity over on your layers palette, I changed mine to soft light. Copy and paste a feather of choice from this kit as a new layer. Resize to size you are happy with I resized mine by 35% and then 75% Add a drop shadow of choice. Copy and paste a bow of choice as a new layer Again resize until you are happy. Once happy place at the end of the feather. Place both the feather and the bow on the top right side of the paper, See my tag as a guide. Copy and paste a flower of choice as a new layer again resize until you are happy with placement. I resized mine by 35% I placed mine in his bottom left side of the paper, Refer to my tag as a guide. Again adding the same previously used drop shadow to each layer. Add any other embellishments that you may wish to use from this wonderful kit, Place as you desire. Add any names and copyright information required. Save as you would normally. That’s it tutorial complete, Thanks for trying my tutorial.